2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

B1243 GSW Terminal Circuit Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

If the collision door lock release function does not operate normally, or an open or short in the GSW input circuit of the main body ECU (driver side junction block assembly) is detected, DTC B1243 is stored.

HINT:
If DTC B1243 is stored, the speed-sensitive automatic door lock function, shift-linked automatic door lock function and collision door lock release function are prohibited.

DTC Code
DTC Detection Condition
Trouble Area
B1243
Either condition is met:
  1. An open or short in the GSW input circuit of the main body ECU (multiplex network body ECU).
  2. The collision door lock release function does not operate normally.
  1. Center airbag sensor assembly
  2. Harness or connector
  3. Main body ECU (multiplex network body ECU)

WIRING DIAGRAM

B243229E01

INSPECTION PROCEDURE

NOTICE:
  1. w/ Navigation system:
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
  2. When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected (Click here).


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC B1243 is output
    A
    DTC B1243 is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - CENTER AIRBAG SENSOR)
  1. Disconnect the cable from the negative (-) battery terminal.

  1. Remove the main body ECU (Click here).

  1. Disconnect the G1 center airbag sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G1-18 (GSW) - A-24 (GSW)
    Always
    Below 1 Ω
    G1-18 (GSW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK MAIN BODY ECU (GSW VOLTAGE)

  1. B217761E03
    Disconnect the cable from the negative (-) battery terminal.

  1. Disconnect the G1 center airbag sensor connector.

  1. Connect the cable to the negative (-) battery terminal.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G1-18 (GSW) - Body ground
    Ignition switch ON
    4.5 to 5.5 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Center Airbag Sensor)



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY (Click here)


← B1243 GSW Terminal Circuit Malfunction (Aug 2013 – Jul 2014)All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side Door Key Cylinder (Aug 2013 – Jul 2014) →