2013-2015 Land Cruiser Prado · Service Manual Brake

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).


3. REMOVE BRAKE PEDAL RETURN SPRING

4. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin from the brake pedal lever.


5. REMOVE STOP LIGHT SWITCH ASSEMBLY
  1. Disconnect the stop light switch connector.

  1. Remove the stop light switch (Click here).


6. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

  1. C215922
    Remove the brake pedal support reinforcement set bolt.

  1. for LHD:
    Remove the hydraulic brake booster assembly (Click here).

  1. for RHD:
    Remove the hydraulic brake booster assembly (Click here).

  1. C214646
    Remove the 4 nut and brake pedal support assembly.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →