2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. for LHD:

    1. Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.

  1. for RHD:

    1. Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.

    2. Install the screw.


2. REMOVE STOP LIGHT SWITCH ASSEMBLY

E286541
  1. Disconnect the connector.

  1. Turn the stop light switch assembly counterclockwise and remove the stop light switch assembly.


3. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

E283667E01
  1. Using a screwdriver, detach the 2 claws and remove the stop light switch mounting adjuster.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Tape

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →