INSPECTION
Inspection · Vehicles built from Aug 2013
| CHECK BRAKE CYLINDER AND PISTON |
Check the cylinder bore and piston for rust or scoring.
If necessary, replace the disc brake cylinder assembly.
| CHECK PAD LINING THICKNESS |
Using a ruler, measure the pad lining thickness.

- Standard thickness:
- 11.3 mm (0.445 in.)
- Minimum thickness:
- 1.0 mm (0.0394 in.)
| CHECK FRONT DISC BRAKE ANTI-RATTLE SPRING |
Use brake cleaner to clean the front disc brake anti-rattle spring. Check for deformation and cracks.
When installing the front disc brake anti-rattle spring to the front disc brake caliper, check that the spring force is applied to the hole pin and brake pad.
| CHECK DISC THICKNESS |
Using a micrometer, measure the disc thickness.

- Standard thickness:
- 32.0 mm (1.26 in.)
- Minimum thickness:
- 29.0 mm (1.14 in.)
| CHECK DISC RUNOUT |
Install the disc with the 6 hub nuts.

- Torque:
- 112 N*m{ 1137 kgf*cm , 82 ft.*lbf }
Using a dial indicator, measure the disc runout 10 mm (0.394 in.) from the outer edge of the disc.
- Maximum disc runout:
- 0.05 mm (0.00197 in.)
Remove the 6 hub nuts and front disc.
