REMOVAL
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
| 2.
DRAIN BRAKE FLUID |
 |
- NOTICE:
- Wash the brake fluid off immediately if it adheres to any painted surfaces.
| 3.
DISCONNECT REAR FLEXIBLE HOSE LH |
 |
- Remove the union bolt and gasket from the rear disc brake cylinder, and then disconnect the rear flexible hose from the rear disc brake cylinder.
- HINT:
- Use a container to catch brake fluid as it drains out.
| 4.
REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY LH |
 |
- Remove the 2 cylinder slide pins from the rear disc brake cylinder.
Remove the rear disc brake cylinder from the rear disc brake cylinder mounting.
| 5.
REMOVE REAR DISC BRAKE PAD |
 |
Remove the 2 rear disc brake pads together with the rear disc brake anti-squeal shims from the rear disc brake cylinder mounting.
| 6.
REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM |
 |
Remove the 2 rear disc brake anti-squeal shims from each rear disc brake pads.
| 7.
REMOVE REAR DISC BRAKE PAD WEAR INDICATOR PLATE |
 |
Remove the rear disc brake pad wear indicator plate from the inner disc brake pad.
| 8.
REMOVE REAR NO. 1 DISC BRAKE PAD SUPPORT PLATE |
 |
- NOTICE:
- If it is necessary to remove the pad support plates, replace them with new ones.
Remove the 2 pad support plates from the rear disc brake cylinder mounting.
| 9.
REMOVE REAR NO. 2 DISC BRAKE PAD SUPPORT PLATE |
 |
- NOTICE:
- If it is necessary to remove the pad support plates, replace them with new ones.
Remove the 2 pad support plates from the rear disc brake cylinder mounting.
| 10.
REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH |
 |
- Remove the 2 bolts, 2 plate washers and rear disc brake cylinder mounting.
| 11.
REMOVE REAR DISC BRAKE BUSH DUST BOOT |
 |
Remove the rear disc brake bush dust boot from the rear disc brake cylinder mounting.
| 12.
REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH |
 |
Remove the rear disc brake cylinder slide bush from the rear disc brake cylinder mounting.
| 13.
REMOVE REAR DISC BRAKE CYLINDER HOLE PLUG |
 |
Remove the rear disc brake cylinder hole plug from the rear disc brake cylinder mounting.
| 14.
REMOVE REAR DISC |
 |
- Put matchmarks on the rear disc and axle hub if planning to reuse the disc.
Text in Illustration
*1
|
Matchmark
|
- Turn the shoe adjuster until the disc turns freely, and then remove the disc.
Text in Illustration
 
|
Shoe Adjuster Contracts
|
 
|
Shoe Adjuster Expands
|