2013-2015 Land Cruiser Prado · Service Manual Brake

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE CYLINDER BOOT

  1. F043127
    Using a screwdriver, remove the cylinder boot from the rear disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE REAR DISC BRAKE PISTON

  1. F043128
    Place a cloth or equivalent between the rear disc brake piston and rear disc brake cylinder.

  1. Using compressed air, remove the rear disc brake piston from the rear disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.

    NOTICE:
    Do not spatter the brake fluid.


3. REMOVE PISTON SEAL

  1. C213453
    Using a screwdriver, remove the piston seal from the rear disc brake cylinder.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.


4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP

5. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug from the rear disc brake cylinder.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →