2013-2015 Land Cruiser Prado · Service Manual Brake

C1381 Acceleration Sensor Power Supply Voltage Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control ECU receives signals from the acceleration sensor via the CAN communication system.
The acceleration sensor detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the acceleration sensor and the CAN communication system, the DTC U0124 (malfunction in CAN communication with the acceleration sensor) are stored.
These DTCs are also stored when calibration has not been completed.
DTC Code
DTC Detection Condition
Trouble Area
C1381
At a vehicle speed of more than 3 km/h (2 mph), the acceleration sensor power source malfunction signal is received for 10 seconds or more.
  1. ECU-IG NO. 1 fuse
  2. Acceleration sensor
  3. Acceleration sensor power source circuit

WIRING DIAGRAM

Refer to DTCs C1243 and C1245 (Click here).

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the acceleration sensor, perform calibration (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK TERMINAL VOLTAGE (IG)
  1. Disconnect the G52 acceleration sensor connector.

  1. C208309E06
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G52-4 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Acceleration Sensor)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (GND TERMINAL)
  1. Disconnect the G52 acceleration sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G52-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. RECONFIRM DTC
  1. Reconnect the acceleration sensor connector.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Perform a road test.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC C1381 is not output
    A
    DTC C1381 is output
    B



B
REPLACE ACCELERATION SENSOR (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1381 Acceleration Sensor Power Supply Voltage Malfunction (Aug 2013 – Jul 2014)C1401 Front Speed Sensor RH Malfunction (+ C1271, C1272, C1402) (Aug 2013 – Jul 2014) →