2013-2015 Land Cruiser Prado · Service Manual Drivetrain

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The ECM communicates with the TCM using the Controller Area Network (CAN).
If there is a problem with this communication, the TCM stores a DTC.
DTC Code
DTC Detection Condition
Trouble Area
U0100
All conditions are met for 1.25 seconds (1-trip detection logic):
  1. Ignition switch is ON.
  2. Battery voltage is 10.5 V or higher.
  3. There is no communication between the ECM and TCM.
  1. Harness or connector
  2. ECM
  3. TCM

WIRING DIAGRAM

C217589E01

INSPECTION PROCEDURE

HINT:
  1. Refer to the inspection procedure for the CAN communication system.
  2. If the CAN communication malfunctions, the TCM cannot receive current data from the ECM. In this case, the freeze frame data output from the TCM has not been updated so the data will not be useful for the inspection. However, reading the Data List as the first step in troubleshooting is an effective way to find malfunctions.
  3. The malfunctioning area can be confirmed using the Bus Check function of the intelligent tester.
    1. for LHD with Entry and Start System: Click here
    1. for LHD without Entry and Start System: Click here
    1. for RHD with Entry and Start System: Click here
    1. for RHD without Entry and Start System: Click here


1. CHECK HARNESS AND CONNECTOR (ECM - TCM)
  1. Disconnect the C92 ECM connector.

  1. Disconnect the G70 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C92-24 (CAN+) - G70-21 (CAN+)
    Always
    Below 1 Ω
    C92-18 (CAN-) - G70-20 (CAN-)
    Always
    Below 1 Ω
    C92-24 (CAN+) or G70-21 (CAN+) - Body ground or other terminals
    Always
    10 kΩ or higher
    C92-18 (CAN-) or G70-20 (CAN-) - Body ground or other terminals
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK IF DTC OUTPUT RECURS (DTC U0100)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Powertrain / ECT / DTC / Clear.

  1. Replace the TCM (Click here).

    HINT:
    Replace the TCM with the TCM of a normally functioning vehicle of the same model.

  1. Start the engine.

  1. Enter the following menus: Powertrain / ECT / DTC.

  1. Read the DTCs using the intelligent tester.

    Result 
    Result
    Proceed to
    U0100 is output
    A
    DTCs are not output
    B



B
REPLACE TCM (Click here)
A

REPLACE ECM (Click here)


← P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (from Aug 2014)U0100 Lost Communication with ECM / PCM "A" (from Aug 2014) →