P2772 Four Wheel Drive (4WD) Low Switch Circuit Range / Performance
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The TCM detects the signal from the transfer L4 position switch.This DTC indicates that the transfer L4 position switch remains on.
| DTC Code |
DTC Detection Condition |
Trouble Area |
| P2772 |
Transfer L4 position switch remains on while the vehicle is being driven under the following conditions for 1.8 sec. or more (1-trip detection logic): (a) Output shaft speed is between 1000 and 3000 rpm. (b) Transfer is in H4. |
|
MONITOR DESCRIPTION
The TCM monitors the transfer-case L4 position switch to determine when the transfer-case L4 gears are engaged. If the L4 position switch indicates that the transfer-case L4 gears are engaged under the following conditions, the TCM will conclude that there is a malfunction of the L4 position switch, illuminate the MIL and store the DTC:- The transfer-case shifter is in the "H4" position.
- The transfer-case output shaft speed is between 1000 and 3000 rpm.
- The specified time period has elapsed.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - BODY GROUND) |
Disconnect the G53 four wheel drive control ECU connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G53-21 (L4) - Body ground
Always
10 kΩ or higher
Text in Illustration *a
Front view of wire harness connector
(to Four Wheel Drive Control ECU)
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (FOUR WHEEL DRIVE CONTROL ECU - TCM) |
Disconnect the G71 TCM connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
G71-15 (L4) - Body ground
Always
10 kΩ or higher
Text in Illustration *a
Rear view of wire harness connector
(to TCM)
|
|
||||
| OK | ||
| ||
