HOW TO PROCEED WITH TROUBLESHOOTING
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use these procedures to troubleshoot the LIN communication system.
- *: Use the intelligent tester.
- Use these procedures to troubleshoot the LIN communication system.
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT BATTERY VOLTAGE |
- Standard voltage:
- 11 to 14 V
| |||||
| 3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Using the intelligent tester, inspect the CAN communication function to make sure that there are no malfunctions in the communication system (Click here).
Result Result
Proceed to
No DTCs are output
A
DTCs are output (for LHD with Entry and Start system)
B
DTCs are output (for LHD without Entry and Start system)
C
DTCs are output (for RHD with Entry and Start system)
D
DTCs are output (for RHD without Entry and Start system)
E
|
|||||
|
|||||
|
|||||
|
|||||
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* |
Using the intelligent tester, inspect the LIN communication function to make sure that there are no malfunctions in the communication system.
Result Result
Proceed to
No DTCs are output
A
DTCs are output
B
|
|||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
Result Result
Proceed to
Fault is not listed in problem symptoms table
A
Fault is listed in problem symptoms table
B
|
|||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List/Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 7.ADJUST, REPAIR OR REPLACE |
| |||||