2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL

3. REMOVE ABSORBER CONTROL ACTUATOR LH

  1. C213631
    Detach the 3 clamps, and then disconnect the connector.

  1. Using a hexagon wrench (4 mm), remove the 2 hexagon socket head cap bolts and absorber control actuator.

    NOTICE:
    Replace the absorber control actuator with a new one if it is dropped.


4. REMOVE SUSPENSION CONTROL BRACKET LH

  1. C115604E01
    Using SST, remove the nut and bracket.
    SST
    09961-00950  

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →