1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
2.
REMOVE FRONT WHEEL
3.
REMOVE ABSORBER CONTROL ACTUATOR LH
Detach the 3 clamps, and then disconnect the connector.
Using a hexagon wrench (4 mm), remove the 2 hexagon socket head cap bolts and absorber control actuator.
NOTICE:
Replace the absorber control actuator with a new one if it is dropped.