2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE LOWER FRONT BUMPER COVER
  1. Remove the clip, 5 bolts and front bumper cover lower.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.

  1. A224743
    Unhook the engine under cover from the vehicle body as shown in the illustration.


4. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY

  1. C214451
    Remove the 6 bolts and 2 member braces from the front frame assembly.


5. REMOVE FRONT STABILIZER END BRACKET (w/ KDSS)

  1. C214452
    Remove the 4 bolts and 2 brackets from the lower arm.


6. REMOVE FRONT STABILIZER BAR (w/ KDSS)

  1. F047879
    Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar.

  1. Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the stabilizer bar front.


7. DISCONNECT FRONT STABILIZER LINK ASSEMBLY LH (w/o KDSS)

  1. C099158
    Remove the nut and disconnect the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


8. DISCONNECT FRONT STABILIZER LINK ASSEMBLY RH (w/o KDSS)

HINT:
Use the same procedure described for the LH side.


9. REMOVE FRONT NO. 1 STABILIZER BRACKET LH (w/o KDSS)

  1. G020162
    Remove the 2 bolts and front No. 1 stabilizer bracket LH.


10. REMOVE FRONT NO. 1 STABILIZER BRACKET RH (w/o KDSS)

HINT:
Use the same procedure described for the LH side.


11. REMOVE FRONT STABILIZER BAR (w/o KDSS)

12. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/ Air Suspension)

  1. G021668E01
    Detach the 3 clamps and disconnect the connector.

  1. Using a 4 mm hexagon wrench, remove the 2 bolts and absorber control actuator.

  1. C115604E01
    Using SST, remove the nut and bracket.
    SST
    09961-00950  

  1. C099159
    Remove the bolt, nut and washer.

  1. G021670
    Remove the 3 nuts on the top of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.


13. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING (w/o Air Suspension)

  1. C099159
    Remove the bolt, nut and washer.

  1. C099160
    Remove the 3 nuts on the top of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →