2013-2015 Land Cruiser Prado · Service Manual Suspension

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT

  1. C099161E02
    Secure SST in a vise.
    SST
    09727-30022   (09727-00010, 09727-00031)
    09727-00060  

  1. C275706E04
    Attach the arm of SST to the diameter of the coil spring.
    Text in Illustration 
    *a
    Correct
    *b
    Incorrect

    CAUTION:
    1. Make sure that the coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the coil spring.

    CAUTION:
    1. If the coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench.

  1. C099162
    Remove the front support to front shock absorber nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the coil spring is not free.


2. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Remove the suspension support, cushion and 2 retainers from the shock absorber rod.


3. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.


4. REMOVE FRONT SHOCK ABSORBER BUSH

  1. C214442E01
    Using SST and a press, remove the absorber bush.
    SST
    09710-30012   (09710-04071, 09710-04081)

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →