REMOVAL
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Use the same procedure for the RH and LH sides.
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE LOWER FRONT BUMPER COVER (w/ KDSS) |
Remove the clip, 5 bolts and front bumper cover lower.
| 3. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY (w/ KDSS) |
Remove the 6 bolts and 2 member braces from the front frame assembly.

| 4. REMOVE FRONT STABILIZER END BRACKET (w/ KDSS) |
Remove the 4 bolts and 2 brackets from the lower arm.

| 5. REMOVE FRONT STABILIZER BAR (w/ KDSS) |
Remove the 4 bolts, 2 front stabilizer lower brackets and front stabilizer bar.

Remove the 2 front stabilizer link bushes and front stabilizer lower bracket bushes from the stabilizer bar front.
| 6. DISCONNECT FRONT SHOCK ABSORBER WITH COIL SPRING |
Remove the bolt, nut and washer.

Disconnect the front shock absorber with coil spring from the suspension lower arm.
| 7. REMOVE FRONT NO. 1 SUSPENSION LOWER ARM SUB-ASSEMBLY LH |
Remove the 2 bolts and disconnect the front lower ball joint attachment LH from the front axle.

Place matchmarks on the No. 2 camber adjust cam and toe adjust cam sub-assembly.

Text in Illustration *a
Matchmark
Remove the nut, No. 2 camber adjust cam, camber adjust cam assembly, bolt, toe adjust cam sub-assembly, No. 2 toe adjust plate and front No. 1 suspension lower arm sub-assembly LH.
Remove the cotter pin and nut.
Using SST, remove the front lower ball joint attachment LH.

- SST
- 09950-40011
(09951-04010, 09954-04010, 09955-04031, 09955-04061, 09958-04011, 09952-04010)
