2013-2015 Land Cruiser Prado · Service Manual Suspension

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL FRONT STABILIZER BAR

2. INSTALL FRONT NO. 1 STABILIZER BAR BUSH

  1. G021678E05
    Install the 2 front No. 1 stabilizer bar bushes.

    HINT:
    1. Install the bush to the inner side of the bushing stopper on the stabilizer bar.
    1. Install the No. 1 stabilizer bush with the protrusion facing inward.

    Text in Illustration 
    *1
    Bushing Stopper
    *a
    Outer Side
    *b
    Front Side
    V100135
    Protrusion


3. INSTALL FRONT NO. 1 STABILIZER BRACKET LH
  1. Install the front No. 1 stabilizer bracket LH with the 2 bolts.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


4. INSTALL FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Use the same procedure described for the LH side.


5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
  1. Install the front stabilizer link assembly LH with the 2 nuts.

    Torque:
    70 N*m{ 714 kgf*cm , 52 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


6. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


7. INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY
  1. Install the 2 member braces with the 6 bolts.

    Torque:
    30 N*m{ 306 kgf*cm , 22 ft.*lbf }


8. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

  1. A224743
    Hook the engine under cover to the vehicle body as shown in the illustration.

  1. Install the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


9. INSTALL LOWER FRONT BUMPER COVER
  1. Install the front bumper cover lower with the 5 bolts and clip.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


10. INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }

← INSPECTION (from Aug 2013)PROBLEM SYMPTOMS TABLE (from Aug 2013) →