2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT WHEEL

2. REMOVE LOWER FRONT BUMPER COVER
  1. Remove the clip, 5 bolts and front bumper cover lower.


3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.

  1. A224743
    Unhook the engine under cover from the vehicle body as shown in the illustration.


4. REMOVE FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY

  1. C214451
    Remove the 6 bolts and 2 member braces from the front frame assembly.


5. REMOVE FRONT STABILIZER LINK ASSEMBLY LH

  1. G020161
    Remove the 2 nuts and front stabilizer link assembly LH.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


6. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.


7. REMOVE FRONT NO. 1 STABILIZER BRACKET LH

  1. G020162
    Remove the 2 bolts and front No. 1 stabilizer bracket LH.


8. REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT:
Use the same procedure described for the LH side.


9. REMOVE FRONT NO. 1 STABILIZER BAR BUSH
  1. Remove the 2 front No. 1 stabilizer bar bushes.


10. REMOVE FRONT STABILIZER BAR
← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →