2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Sliding Roof ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2013

DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof drive gear sub-assembly power source circuit.

WIRING DIAGRAM

B243268E01

INSPECTION PROCEDURE

NOTICE:
  1. When the sliding roof drive gear sub-assembly is removed and reinstalled or replaced, the sliding roof drive gear sub-assembly must be initialized (Click here).
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)
B243668E01
  1. Disconnect the W2 ECU connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    W2-2 (E) - Body ground
    Always
    Below 1 Ω
    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    W2-1 (B) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Sliding Roof Drive Gear Sub-assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY (Click here)


← Sliding Roof Control Switch Circuit (from Aug 2013)COMPONENTS (from Aug 2013) →