2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

  1. B236463
    Detach the bracket claw and remove the bracket.

  1. Remove the 2 bolts and drive gear.


2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY

B236465E01
Text in Illustration 
*a
Rearward
-
-
  1. Remove the 2 screws.

  1. Detach the 4 claws and remove the sliding roof piece LH and RH.

  1. Slide and remove the trim.


3. REMOVE SLIDING ROOF SUNSHADE STOPPER LH

  1. B178631
    Remove the stopper.


4. REMOVE SLIDING ROOF SUNSHADE STOPPER RH

HINT:
Use the same procedure described for the LH side.


5. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

NOTICE:
Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.

  1. Remove the 2 screws and 2 stoppers.

    B236467

  1. B236468E01
    Using a screwdriver, detach the 2 claws and slide the rear roof drip channel rearward to remove it.
    Text in Illustration 
    *1
    Protective Tape
    *a
    Rearward

    HINT:
    Tape the screwdriver tip before use.

  1. B236469
    Hold down the window deflector.

  1. B236470E01
    Place matchmarks on the sliding roof drive cable sub-assembly at locations A and B as shown in the illustration.
    Text in Illustration 
    *1
    Matchmark A
    *2
    Matchmark B

  1. B236471E01
    Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.
    Text in Illustration 
    *1
    Protective Tape
    V100135
    Slide

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (from Aug 2014)REASSEMBLY (from Aug 2013) →