2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ECU Power Source Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit provides power to operate the transponder key ECU assembly.

WIRING DIAGRAM

B235882E06

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND)

  1. B242622E04
    Disconnect the G138*1 or G74*2 ECU connector.
    1. *1: for 5L-E
    2. *2: except 5L-E

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    for 5L-E 
    Tester Connection
    Switch Condition
    Specified Condition
    G138-1 (+B) - Body ground
    Always
    11 to 14 V
    G138-2 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V
    except 5L-E 
    Tester Connection
    Switch Condition
    Specified Condition
    G74-1 (+B) - Body ground
    Always
    11 to 14 V
    G74-2 (IG) - Body ground
    Ignition switch off
    Below 1 V
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for 5L-E 
    Tester Connection
    Condition
    Specified Condition
    G138-16 (GND) - Body ground
    Always
    Below 1 Ω
    except 5L-E 
    Tester Connection
    Condition
    Specified Condition
    G74-16 (GND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*A
for 5L-E
*B
except 5L-E
*a
Front view of wire harness connector
(to Transponder Key ECU Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← ECU Power Source Circuit (Aug 2013 – Jul 2014)PRECAUTION (from Aug 2013) →