ECU Power Source Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit provides power to operate the transponder key ECU assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - BATTERY AND BODY GROUND) |
Disconnect the G138*1 or G74*2 ECU connector.

- *1: for 5L-E
- *2: except 5L-E
- *1: for 5L-E
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
for 5L-E Tester Connection
Switch Condition
Specified Condition
G138-1 (+B) - Body ground
Always
11 to 14 V
G138-2 (IG) - Body ground
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
except 5L-E Tester Connection
Switch Condition
Specified Condition
G74-1 (+B) - Body ground
Always
11 to 14 V
G74-2 (IG) - Body ground
Ignition switch off
Below 1 V
Ignition switch ON
11 to 14 V
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for 5L-E Tester Connection
Condition
Specified Condition
G138-16 (GND) - Body ground
Always
Below 1 Ω
except 5L-E Tester Connection
Condition
Specified Condition
G74-16 (GND) - Body ground
Always
Below 1 Ω
| *A |
for 5L-E |
| *B |
except 5L-E |
| *a |
Front view of wire harness connector (to Transponder Key ECU Assembly) |
|
|
||||
| OK | ||
| ||
