2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT STOP LIGHT CONTROL ECU ASSEMBLY

  1. E173014E05
    Disconnect the A52 stop light control ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A52-5 (STP) - Body ground
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V
    A52-6 (+B) - Body ground
    Always
    11 to 14 V

    If the result is not as specified, repair or replace the wire harness or connector.
    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Stop Light Control ECU Assembly)

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A52-8 (GND) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, repair or replace the wire harness or connector.

  1. E173013E05
    Reconnect the A52 stop light control ECU assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A52-1 (OUT) - Body ground
    Brake pedal released
    Below 1 V
    Brake pedal depressed
    11 to 14 V

    If the result is not as specified, the stop light control ECU assembly may have a malfunction.
    Text in Illustration 
    *a
    Component with harness connected
    (to Stop Light Control ECU Assembly)

← REMOVAL (from Aug 2014)INSTALLATION (Aug 2013 – Jul 2014) →