Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The radio and display receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the H49 radio and display receiver assembly connector.
Disconnect the H63 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H49-6 (FL-) - H63-2 (L-)
Always
Below 1 Ω
H49-2 (FL+) - H63-3 (L+)
Always
Below 1 Ω
H49-5 (FR-) - H63-4 (R-)
Always
Below 1 Ω
H49-1 (FR+) - H63-5 (R+)
Always
Below 1 Ω
H49-6 (FL-) - Body ground
Always
10 kΩ or higher
H49-2 (FL+) - Body ground
Always
10 kΩ or higher
H49-5 (FR-) - Body ground
Always
10 kΩ or higher
H49-1 (FR+) - Body ground
Always
10 kΩ or higher
H63-6 (SLD) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
