Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY) |
Disconnect the H58 navigation receiver assembly connector.
Disconnect the H68 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H58-2 (US1-) - H68-2 (US1-)
Always
Below 1 Ω
H58-3 (US1+) - H68-3 (US1+)
Always
Below 1 Ω
H58-2 (US1-) - Body ground
Always
10 kΩ or higher
H58-3 (US1+) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
