2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.
The sound signal that has been sent is amplified by the radio and display receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM

B360078E11

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

  1. Disconnect the H51 radio and display receiver assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H68-8 (VAL+) - H51-28 (VAL+)
    Always
    Below 1 Ω
    H68-7 (VAR+) - H51-26 (VAR+)
    Always
    Below 1 Ω
    H68-9 (VA-) - H51-27 (VA-)
    Always
    Below 1 Ω
    H68-12 (AGND) - H51-11 (AGND)
    Always
    Below 1 Ω
    H68-10 (ADPG) - H51-25 (ADPG)
    Always
    Below 1 Ω
    H51-12 (SG) - Body ground
    Always
    10 kΩ or higher
    H68-8 (VAL+) - Body ground
    Always
    10 kΩ or higher
    H68-7 (VAR+) - Body ground
    Always
    10 kΩ or higher
    H68-9 (VA-) - Body ground
    Always
    10 kΩ or higher
    H68-12 (AGND) - Body ground
    Always
    10 kΩ or higher
    H68-10 (ADPG) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter (Aug 2013 – Jul 2014)Data Signal Circuit between Stereo Jack Adapter and Extension Module (Aug 2013 – Jul 2014) →