2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Data Signal Circuit between Stereo Jack Adapter and Extension Module

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation ECU via this circuit.

WIRING DIAGRAM

E281004E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the A navigation ECU connector.

  1. Disconnect the H68 No. 1 stereo jack adapter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A-2 (US1-) - H68-2 (US1-)
    Always
    Below 1 Ω
    A-3 (US1+) - H68-3 (US1+)
    Always
    Below 1 Ω
    A-2 (US1-) - Body ground
    Always
    10 kΩ or higher
    A-3 (US1+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Data Signal Circuit between Stereo Jack Adapter and Extension Module (Aug 2013 – Jul 2014)Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier (Aug 2013 – Jul 2014) →