2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Navigation Voice Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.
Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E282421E05

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY)
  1. Disconnect the H60 navigation receiver assembly connector.

  1. Disconnect the H63 stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H63-15 (II1+) - H60-2 (RL+)
    Always
    Below 1 Ω
    H63-14 (II1-) - H60-6 (RL-)
    Always
    Below 1 Ω
    H63-15 (II1+) - Body ground
    Always
    10 kΩ or higher
    H63-14 (II1-) - Body ground
    Always
    10 kΩ or higher
    H63-18 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Navigation Voice Circuit (Aug 2013 – Jul 2014)Microphone Circuit between Microphone and Navigation Receiver Assembly (Aug 2013 – Jul 2014) →