Navigation Voice Circuit
Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This circuit is used when the voice guidance in the navigation system is on or an incoming cellular phone voice in the "Bluetooth" hands-free system is heard.Using this circuit, the navigation receiver assembly sends the signals to the stereo component amplifier assembly.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY- STEREO COMPONENT AMPLIFIER ASSEMBLY) |
Disconnect the H60 navigation receiver assembly connector.
Disconnect the H63 stereo component amplifier connector.
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
H63-15 (II1+) - H60-2 (RL+)
Always
Below 1 Ω
H63-14 (II1-) - H60-6 (RL-)
Always
Below 1 Ω
H63-15 (II1+) - Body ground
Always
10 kΩ or higher
H63-14 (II1-) - Body ground
Always
10 kΩ or higher
H63-18 (SLD1) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
