2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE REAR NO. 1 SPOILER COVER

B247537E01
  1. Detach the fastening tape and 5 clips and remove the rear No. 1 spoiler cover.

    Text in Illustration 
    *1
    Fastening Tape


2. REMOVE REAR SPOILER COVER RH

B247537E01
  1. Detach the fastening tape and 5 clips and remove the rear No. 1 spoiler cover.

    Text in Illustration 
    *1
    Fastening Tape


3. REMOVE REAR SPOILER SUB-ASSEMBLY

  1. B236289
    Disconnect the connector.

  1. B237904
    Remove the 6 bolts.

  1. B241000
    Detach the 3 clips and rear spoiler.


4. REMOVE REAR WIPER ARM

  1. E197697
    Remove the nut and rear wiper arm.


5. REMOVE REAR WIPER MOTOR ASSEMBLY

  1. E197698E01
    Disconnect the washer hose and wiper motor connector.
    Text in Illustration 
    *A
    w/ Back Door Tire Carrier
    *B
    w/o Back Door Tire Carrier

  1. E197701E01
    Remove the 3 bolts.
    Text in Illustration 
    *A
    w/ Back Door Tire Carrier
    *B
    w/o Back Door Tire Carrier

  1. Detach the 2 guides and remove the rear wiper motor.


6. REMOVE BACK WINDOW STAY ASSEMBLY LH

  1. B238986E01
    Using a screwdriver, remove the 2 stop rings as shown in the illustration, and then remove the back window stay.

    CAUTION:
    Remove the back window stay while supporting the back door with one hand.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape


7. REMOVE BACK WINDOW STAY ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


8. REMOVE BACK DOOR GLASS

  1. B242843
    Remove the connector and detach the 2 clamps.

  1. B239004
    Remove the 4 bolts and back window glass.


9. REMOVE BACK DOOR LOCK STRIKER COVER

B239005
  1. Using a moulding remover, detach the 3 claws and remove the lock striker cover.


10. REMOVE BACK WINDOW LOCK STRIKER ASSEMBLY

B242844E01
  1. Remove the 2 nuts and lock striker.


11. REMOVE BACK WINDOW GLASS SPACER

B239006E01

HINT:
Perform the following procedures if replacing the back window glass spacer.

  1. Remove the back window glass spacer.

    Text in Illustration 
    *1
    No. 2 Back Window Glass Spacer
    *2
    No. 1 Back Window Glass Spacer


12. REMOVE BACK DOOR HINGE ASSEMBLY LH

B242845E01

HINT:
Perform the following procedures if replacing any back door hinge assembly LH.

  1. Using a T30 "TORX" wrench, remove the 2 screws and back door hinge.


13. REMOVE BACK DOOR HINGE ASSEMBLY RH

HINT:
Use the same procedure described for the LH side.

← COMPONENTS (from Aug 2013)ADJUSTMENT (from Aug 2013) →