2013-2015 Land Cruiser Prado · Service Manual Drivetrain

ECU Power Source Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.

WIRING DIAGRAM

Refer to DTC P0560 (Click here).

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK TCM (TCM - BODY GROUND)

  1. C212047E13
    Disconnect the G69 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G69-1 (E1) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to TCM)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - TCM)
  1. Disconnect the No. 1 integration relay 1A connector.

  1. Disconnect the G70 TCM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1A-4 - G70-6 (IG2)
    Always
    Below 1 Ω
    1A-4 or G70-6 (IG2) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK (w/ DPF)
    A
    OK (w/o DPF)
    B
    NG
    C



B
GO TO ECD SYSTEM (ECM POWER SOURCE CIRCUIT) (Click here)

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

GO TO ECD SYSTEM (ECM POWER SOURCE CIRCUIT) (Click here)


← L4 Position Switch Circuit (from Aug 2014)ECU Power Source Circuit (from Aug 2014) →