REPLACEMENT
Removal / installation · Vehicles built from Aug 2013
| 1. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH |
Remove the front drive shaft assembly LH (Click here).
| 2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.
| 3. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
![]() ![]() |
Using SST, tap out the 2 oil seals.
- SST
- 09308-10010
| 4. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL |
Apply MP grease to 2 new oil seals.
Using SST and a hammer, tap in the 2 oil seals.

- SST
- 09550-00032
09950-70010 (09951-07100)
- Standard Oil Seal Depth:
Item
Specified Condition
LH side
-0.45 to 0.45 mm (-0.018 to 0.018 in.)
RH side
4.8 to 5.8 mm (0.189 to 0.229 in.)
Text in Illustration *1
Differential
*2
Seal
*a
LH side
*b
RH side
- NOTICE:
- Make sure the LH and RH oil seals are installed in the proper locations.
| 5. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH |
Install the front drive shaft assembly LH (Click here).
| 6. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH |
- HINT:
- Use the same procedure described for the LH side.

