2013-2015 Land Cruiser Prado · Service Manual Steering

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).

    NEXT

    3.INSPECT BATTERY VOLTAGE*
    1. Measure the voltage of the battery.

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    NEXT

    4.CHECK DTC*
    1. Check and record DTCs.

    NEXT

    5.CLEAR DTC*
    1. Clear the DTCs.

    NEXT

    6.PROBLEM SYMPTOM CONFIRMATION
      Result 
      Result
      Proceed to
      Symptom does not occur.
      A
      Symptom occurs.
      B

    B.
    A

    7.SYMPTOM SIMULATION
    1. Perform symptom simulation (Click here).

    NEXT

    8.CHECK CAN COMMUNICATION SYSTEM*
    1. Check for DTCs (Click here).

      Result 
      Result
      Proceed to
      CAN communication system DTC is not output.
      A
      CAN communication system DTC is output.
      B

      HINT:
      1. If any CAN communication system DTCs are output, perform troubleshooting for the CAN communication system first.
      2. for LHD with Entry and Start System:
        1. Refer to the following procedures (Click here).
        for LHD without Entry and Start System:
        1. Refer to the following procedures (Click here).
        for RHD with Entry and Start System:
        1. Refer to the following procedures (Click here).
        for RHD without Entry and Start System:
        1. Refer to the following procedures (Click here).
      3. If communication with the power steering ECU cannot be established through the intelligent tester, inspect terminals CANH and CANL of the DLC3 and power steering ECU, and the IG circuit of the power steering ECU.


    B.
    A

    9.CHECK FOR DTC*
    1. Check for DTCs (Click here).

      HINT:
      Refer to Diagnostic Trouble Code Chart when any DTCs are output (Click here).

      Result 
      Result
      Proceed to
      DTC is not output.
      A
      DTC is output.
      B


    B.
    A

    10.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

    NEXT

    11.CIRCUIT INSPECTION
      NEXT

      12.IDENTIFICATION OF PROBLEM
        NEXT

        13.REPAIR OR REPLACE
          NEXT

          14.CONFIRMATION TEST
            NEXT

            ← SYSTEM DESCRIPTION (from Aug 2013)HOW TO PROCEED WITH TROUBLESHOOTING (from Aug 2014) →