2013-2015 Land Cruiser Prado · Service Manual Steering

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The power steering ECU receives signals from the ECM, steering angle sensor and skid control ECU via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
U0100
The engine speed signal is lost.
  1. ECM
  2. CAN communication system
  3. Power steering ECU assembly
U0126
The steering angle signal is lost.
  1. Steering angle sensor (Spiral cable sub-assembly)
  2. CAN communication system
  3. Power steering ECU assembly
U0129
The vehicle speed signal is lost.
  1. Skid control ECU
  2. CAN communication system
  3. Power steering ECU assembly

INSPECTION PROCEDURE


1. CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Clear the DTC(s) (Click here).

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    for LHD with Entry and Start System
    B
    for LHD without Entry and Start System
    C
    for RHD with Entry and Start System
    D
    for RHD without Entry and Start System
    E



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C15F1 Steering Angle Sensor Circuit (from Aug 2014)U0100 Lost Communication with ECM / PCM "A" (+ U0126, U0129) (from Aug 2014) →