2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
  1. Remove the manual transmission unit assembly (Click here).


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
  1. Remove the automatic transmission assembly (Click here).


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

  1. C215531E01
    Place matchmarks on the clutch cover and flywheel.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.


5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. G038108E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A222354
    Remove the 10 bolts and flywheel.


6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. G038108E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A222355
    Remove the 10 bolts, rear drive plate spacer, drive plate and front drive plate spacer.


7. REMOVE ENGINE REAR OIL SEAL

  1. G037552E02
    Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position
    *2
    Protective Tape

  1. Using a screwdriver pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    1. Do not damage the surface of the oil seal press fit hole or the crankshaft.
    2. After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

← REMOVAL (Aug 2013 – Jul 2014)INSTALLATION (Aug 2013 – Jul 2014) →