REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1.
REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission) |
 |
Remove the manual transmission unit assembly (Click here).
| 2.
REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission) |
 |
Remove the automatic transmission assembly (Click here).
| 3.
REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
|
 |
- Place matchmarks on the clutch cover and flywheel.
Text in Illustration
*a
|
Matchmark
|
Loosen each set bolt one turn at a time until spring tension is released.
Remove the 6 set bolts and pull off the clutch cover.
- NOTICE:
- Do not drop the clutch disc.
| 4.
REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
|
 |
- NOTICE:
- Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.
| 5.
REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission) |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 10 bolts and flywheel.
| 6.
REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission) |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Remove the 10 bolts, rear drive plate spacer, drive plate and front drive plate spacer.
| 7.
REMOVE ENGINE REAR OIL SEAL |
 |
- Using a knife, cut off the lip of the oil seal.
Text in Illustration
*1
|
Cut Position
|
*2
|
Protective Tape
|
Using a screwdriver pry out the oil seal.
- HINT:
- Tape the screwdriver tip before use.
- NOTICE:
- Do not damage the surface of the oil seal press fit hole or the crankshaft.
- After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.