2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

B2313 Glass Position Initialization Incomplete

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor assembly has a motor, regulator and ECU.
When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:
This DTC may be stored for all the windows.

NOTICE:
  1. When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  2. After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the auto up position.
    2. Open the power window by fully pushing down the power window switch.

D-Door Motor 
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
  1. Front power window regulator motor LH*1
  2. Front power window regulator motor RH*2
  1. *1: for LHD
  2. *2: for RHD
P-Door Motor 
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
  1. Front power window regulator motor RH*1
  2. Front power window regulator motor LH*2
  1. *1: for LHD
  2. *2: for RHD
RL-Door Motor (for 5 Door) 
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
Rear power window regulator motor LH
RR-Door Motor (for 5 Door) 
DTC Code
DTC Detection Condition
Trouble Area
B2313
Either condition is met:
  1. Power window regulator motor is not initialized.
  2. Power window regulator motor malfunctions.
Rear power window regulator motor RH

INSPECTION PROCEDURE


1. PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Initialize the power window regulator motor (Click here).


NEXT


2. CHECK DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B2313 is not output

    Result 
    Result
    Proceed to
    No DTCs output
    A
    DTC output (Front power window LH)
    B
    DTC output (Front power window RH)
    C
    DTC output (Rear power window LH)*
    D
    DTC output (Rear power window RH)*
    E
    1. *: for 5 Door



B
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

C
REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)

D
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (Click here)

E
REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)


← B2313 Glass Position Initialization Incomplete (Aug 2013 – Jul 2014)Remote Up / Down Function does not Operate (Aug 2013 – Jul 2014) →