2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
  1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.


2. INSTALL VVT SENSOR (for Intake Side of Bank 2)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.


3. INSTALL VVT SENSOR (for Exhaust Side of Bank 1)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.


4. INSTALL VVT SENSOR (for Intake Side of Bank 1)
  1. Apply a light coat of engine oil to the O-ring of the sensor.

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.


5. INSTALL NO. 1 AIR CLEANER HOSE

  1. A225179E01
    Install the air cleaner hose with the 2 clamps.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    Text in Illustration 
    *1
    Paint mark
    *a
    Protrusion
    *b
    Groove
    *c
    Top
    *d
    RH
    *e
    Front

  1. Install the bolt.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Connect the vacuum hose and ventilation hose.

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Attach the wire harness clamp.


6. INSTALL V-BANK COVER

  1. A229926E01
    Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins and press down on the V-bank cover to attach the pins.
    Text in Illustration 
    *1
    Pin
    *2
    Hook

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →