U0100 Lost Communication with ECM / PCM "A"
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Also covers:
- U0129 Lost Communication with Skid Control ECU
- U0131 Lost Communication with Power Steering Control Module
- U0142 Lost Communication with Main Body ECU
- U0151 Lost Communication with Airbag ECU
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The combination meter assembly communicates with the ECM via the CAN communication system (CAN No. 1 Bus).| DTC No. |
DTC Detection Condition |
Trouble Area |
| U0100 |
When the vehicle speed is 5 km/h (3.1 mph) or more, IG voltage is 9.5 V or more, and the following conditions is detected:
|
|
| U0129 |
When 15 seconds have elapsed since engine started, IG voltage is 9.5 V or more, and the following conditions is detected:
|
|
| U0131*1 |
When the vehicle speed is 5 km/h (3.1 mph) or more, IG voltage is 9.5 V or more, and the following conditions is detected:
|
|
| U0142*2 |
When the vehicle speed is 5 km/h (3.1 mph) or more, IG voltage is 9.5 V or more, and the following conditions is detected:
|
|
| U0151 |
When the vehicle speed is 5 km/h (3.1 mph) or more, IG voltage is 9.5 V or more, and the following conditions is detected:
|
|
- *1: except 5L-E
- *2: for Optitron Meter
INSPECTION PROCEDURE
| 1. CONFIRM DTC OUTPUT |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to on.
Turn the intelligent tester on.
Enter the following menus: Body Electrical / Trouble Codes.
Clear the stored DTCs.
Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.
Stop the vehicle.
Check for DTCs (Click here).
Result Result
Proceed to
CAN communication system DTC is not output
A
CAN communication system DTC is output (for LHD with Entry and Start System)
B
CAN communication system DTC is output (for LHD without Entry and Start System)
C
CAN communication system DTC is output (for RHD with Entry and Start System)
D
CAN communication system DTC is output (for RHD without Entry and Start System)
E
- HINT:
- If CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 first.
|
|
||||
|
|
||||
|
|
||||
|
|
||||
| A | ||
| ||
