2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL FRONT CRANKSHAFT OIL SEAL

  1. A221100E01
    Apply MP grease to the lip of a new oil seal.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

    SST
    09226-10010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap the oil seal at an angle.


2. INSTALL CRANKSHAFT PULLEY

  1. A076309E03
    Using SST, install the crankshaft pulley with the pulley set bolt.
    SST
    09213-54015   (91651-60855)
    09330-00021  

    Torque:
    260 N*m{ 2651 kgf*cm , 192 ft.*lbf }


3. INSTALL OIL FILTER BRACKET
  1. Install the oil filter bracket and a new gasket with the 2 nuts and bolt.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }


4. CONNECT WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)

  1. A224742E01
    Connect the 2 hoses and water by-pass pipe.
    Text in Illustration 
    *1
    Upward
    *2
    Rearward

    HINT:
    The direction of the hose clamp is indicated in the illustration.

  1. Install the 3 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }


5. INSTALL RADIATOR ASSEMBLY
  1. Install the radiator (Click here).

← REMOVAL (from Aug 2013)COMPONENTS (from Aug 2013) →