2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator (Click here).


2. DISCONNECT WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)

  1. A225377
    Remove the 3 bolts.

  1. A222108
    Disconnect the 2 hoses and water by-pass pipe.


3. REMOVE OIL FILTER BRACKET

  1. A223672E01
    Remove the 2 nuts, bolt, oil filter bracket and gasket.
    Text in Illustration 
    *A
    w/ Oil Cooler
    *B
    w/o Oil Cooler


4. REMOVE CRANKSHAFT PULLEY

  1. A072947E04
    Using SST, hold the crankshaft pulley and loosen the pulley bolt. Continue to loosen the bolt until only 2 or 3 threads are screwed into the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A072948E02
    Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05031)


5. REMOVE FRONT CRANKSHAFT OIL SEAL

  1. A221099
    Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or crankshaft.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →