2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
  1. Remove the automatic transmission (Click here).


2. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)
  1. Remove the manual transmission (Click here).


3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

  1. A224775E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224777
    Remove the 8 bolts, rear spacer, drive plate and front spacer.


4. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

  1. C215502E01
    Put matchmarks on the clutch cover and flywheel.
    Text in Illustration 
    *a
    Matchmark

  1. Loosen each set bolt one turn at a time until spring tension is released.

  1. Remove the 6 set bolts and pull off the clutch cover.

    NOTICE:
    Do not drop the clutch disc.


5. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.


6. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

  1. A224775E01
    Using SST, hold the crankshaft.
    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224776
    Remove the 8 bolts and flywheel.

    NOTICE:
    Do not reuse the bolts.


7. REMOVE REAR CRANKSHAFT OIL SEAL

  1. A076328E03
    Using a knife, cut off the lip of the oil seal.
    Text in Illustration 
    *1
    Cut Position

  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole or crankshaft.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →