INSTALLATION
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. INSTALL HEIGHT CONTROL DRYER ASSEMBLY |
Install a new O-ring.
Install the height control dryer with the bolt.
- Torque:
- 6.4 N*m{ 65 kgf*cm , 57 in.*lbf }
Connect the No. 2 height control tube (Click here).

- HINT:
- For the connection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.
| 2. INSTALL HEIGHT CONTROL COMPRESSOR ASSEMBLY |
Install the height control compressor to the bracket with the 3 bolts.
- Torque:
- 5.9 N*m{ 60 kgf*cm , 52 in.*lbf }
Connect the connector.
Attach the clamp.
Attach the 3 clamps.
Connect the connector.
Attach the No. 2 height control tube.
| 3. CONNECT NO. 2 HEIGHT CONTROL TUBE |
Connect the No. 2 height control tube (Click here).

- HINT:
- For the connection procedure of the tube (type 2), refer to Precaution of the Suspension Control System section.
| 4. INSTALL HEIGHT CONTROL FILTER |
Install the height control filter with the 2 bolts.
- Torque:
- 6.4 N*m{ 65 kgf*cm , 57 in.*lbf }
Connect the 2 hoses with 2 new clips.
| 5. CHECK CONNECTION OF TUBES FOR AIR LEAK |
| 6. INSTALL REAR BUMPER PROTECTOR SUB-ASSEMBLY LH (for 5 Door) |
Install the rear bumper protector with the screw.
| 7. INSTALL HEIGHT CONTROL COMPRESSOR COVER |
Install the height control compressor cover with 3 new clips.
| 8. INSTALL REAR QUARTER PANEL MUDGUARD SUB-ASSEMBLY LH |
Install the rear quarter panel mudguard with the 5 screws and 2 clips.
| 9. INSTALL REAR WHEEL LH |
- Torque:
- 112 N*m{ 1142 kgf*cm , 83 ft.*lbf }
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
- NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
