2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Park / Neutral Position Switch Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit sends the park/neutral position switch assembly signals to the clearance warning ECU.

WIRING DIAGRAM

E202337E07

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

  1. E179071E09
    Disconnect the C40 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever not in R
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for A750F)
    B
    NG (for A343F)
    C



B
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (Click here)
A


2. CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - BATTERY)

  1. E146355E05
    Disconnect the C40 park/neutral position switch assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    C40-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Park/Neutral Position Switch Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - PARK/NEUTRAL POSITION SWITCH)
  1. Disconnect the I1 clearance warning ECU connector.

  1. Disconnect the C40 park/neutral position switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I1-13 (RL) - C40-1 (RL)
    Always
    Below 1 Ω
    I1-13 (RL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Park / Neutral Position Switch Circuit (Aug 2013 – Jul 2014)Back-up Light Circuit (Aug 2013 – Jul 2014) →