2.
REMOVE EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)
Remove the 3 nuts and emission control valve set.
3.
REMOVE NO. 2 EMISSION CONTROL VALVE SET (w/ Secondary Air Injection System)
Remove the 3 nuts and No. 2 emission control valve set.
4.
REMOVE IGNITION COIL ASSEMBLY
Disconnect the 6 ignition coil connectors.
Remove the 6 bolts and 6 ignition coils.
5.
REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the dipstick.
Remove the bolt and dipstick guide.
Remove the O-ring from the dipstick guide.
6.
REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)
Disconnect the 2 hoses.
Remove the 3 bolts and water by-pass pipe.
7.
REMOVE WATER INLET HOUSING
Disconnect the 3 water by-pass hoses.
Remove the 5 bolts and water inlet housing.
Remove the O-ring and gasket from the water outlet pipe and water pump.
Remove the 3 water by-pass hoses.
8.
REMOVE NO. 1 IDLER PULLEY SUB-ASSEMBLY
Remove the bolt and No. 1 idler pulley.
9.
REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
for Cover Separate Type: Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulleys and 2 No. 2 idler pulley cover plates.
for Cover Integrated Type: Remove the 2 bolts and 2 No. 2 idler pulleys.
10.
REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 5 bolts and V-ribbed belt tensioner.
11.
REMOVE OIL FILTER BRACKET
Remove the 2 nuts, bolt, oil filter bracket and gasket.
Text in Illustration
*A
w/ Oil Cooler
*B
w/o Oil Cooler
12.
REMOVE CRANKSHAFT PULLEY
Using SST, hold the crankshaft pulley and loosen the pulley bolt. Continue to loosen the bolt until only 2 or 3 threads are screwed into the crankshaft.
SST
09213-54015
(91651-60855)
09330-00021
Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.