2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. REMOVE SKID CONTROL SENSOR WIRE

  1. C212840
    Disconnect the connector from the front speed sensor.

  1. Remove the 2 bolts and 2 harness clamps.

  1. Detach the clip.

  1. C212841
    Remove the 2 bolts and 2 harness clamps.

  1. Disconnect the connector as follows.

    C212843E01

    Text in Illustration 
    *A
    for LH
    *B
    for RH

    1. for LH:

      1. Disconnect the connector.
      2. Detach the connector.

    2. for RH:

      1. Disconnect the connector.
      2. Detach the connector from the skid control sensor clamp.
      3. Detach the clip.
      4. Remove the bolt and skid control sensor clamp.


3. REMOVE FRONT SUSPENSION UPPER ARM ASSEMBLY LH

  1. G020151E03
    Support the front suspension lower arm LH with a jack.

  1. Remove the clip and nut.

  1. Using SST, disconnect the upper ball joint from the steering knuckle.

    SST
    09628-62011  

  1. C214444
    Remove the bolt and disconnect the bracket.

  1. G020153
    Remove the bolt, 2 washers and nut.

  1. Remove the front suspension upper arm assembly.

← ON-VEHICLE INSPECTION (from Aug 2013)DISASSEMBLY (from Aug 2013) →