2013-2015 Land Cruiser Prado · Service Manual Suspension

INSTALLATION

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH (w/ Air Suspension)
  1. Install the cushion No. 2 to the rear shock absorber assembly LH.

  1. C214690
    C214691
    Install the cushion No. 1 and rear shock absorber assembly LH with a new nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    Be sure to fit the positioning protrusion of the bracket into the hole in the frame.

  1. D028132
    Temporarily install the rear shock absorber assembly LH with the bolt.

  1. Connect the absorber control actuator connector.


2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH (w/o Air Suspension)
  1. Install the cushion No. 2 to the rear shock absorber assembly LH.

  1. D028133
    Temporarily install the cushion No. 1 and rear shock absorber assembly LH with a new nut.

  1. D028132
    Temporarily install the rear shock absorber assembly LH with the bolt.

  1. Tighten the nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }


3. INSTALL REAR WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }


4. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Bounce the vehicle up and down several times to stabilize the suspension.


5. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
  1. Tighten the bolt.

    Torque:
    98 N*m{ 999 kgf*cm , 72 ft.*lbf }

← INSPECTION (from Aug 2013)DISPOSAL (from Aug 2013) →