2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE REAR WHEEL

2. REMOVE REAR STABILIZER LOWER BRACKET (w/ KDSS)

  1. C214450
    Remove the 4 bolts and 2 rear stabilizer lower brackets.


3. DISCONNECT REAR SHOCK ABSORBER ASSEMBLY LH
  1. Support the rear axle housing.

  1. D028132
    Remove the bolt on the lower side of the shock absorber.

  1. Disconnect the shock absorber from the axle housing.


4. DISCONNECT REAR FLEXIBLE HOSE

  1. C214598
    Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the rear flexible hose.

  1. C214599
    Disconnect each brake tube from the rear flexible hose with a union nut wrench while holding the rear flexible hose with a wrench.

  1. Remove the 2 clips.

  1. Remove the rear flexible hose.


5. REMOVE REAR COIL SPRING LH
  1. While lowering the axle housing, remove the coil spring.

    NOTICE:
    Be careful not to snap the brake line and parking brake cable.


6. REMOVE HOLLOW SPRING SUB-ASSEMBLY (for 5 Door)
  1. Remove the hollow spring from the frame.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →