2013-2015 Land Cruiser Prado · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. REMOVE REAR WHEEL

2. DISCONNECT REAR HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (w/ Air Suspension)

  1. C212872
    Disconnect the connector, and then detach the connector.

  1. Detach the clamp.

  1. C212873E01
    Place matchmarks on the link and bracket.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the nut and disconnect the sensor link.

  1. Remove the 2 bolts and height control sensor.

    NOTICE:
    Replace the rear height control sensor sub-assembly with a new one if it is dropped.


3. REMOVE REAR UPPER CONTROL ARM ASSEMBLY LH

  1. D029803
    Remove the nut, washer and bolt from the rear axle housing.

    HINT:
    Turn the nut while holding the bolt.

  1. D029804
    Remove the nut, washer, bolt and upper control arm assembly.

    HINT:
    Turn the nut while holding the bolt.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →