2013-2015 Land Cruiser Prado · Service Manual Brake

43 ABS Control System Malfunction

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This DTC is output when the VSC system detects a malfunction in the ABS.
DTC Code
DTC Detection Condition
Trouble Area
43
A malfunction in the anti-lock brake system.
Anti-lock brake system

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform calibration (Click here).


1. CHECK ANTI-LOCK BRAKE SYSTEM
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC not output (ABS DTC)
    A
    DTC output (ABS DTC)
    B



B
REPAIR CIRCUIT INDICATED BY OUTPUT DTC (Click here)
A


2. RECONFIRM DTC
  1. Turn the ignition switch off.

  1. Clear the DTCs (Click here).

  1. Start the engine.

  1. Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← DIAGNOSTIC TROUBLE CODE CHART (from Aug 2014)43 ABS Control System Malfunction (from Aug 2014) →