43 ABS Control System Malfunction
Diagnostic trouble codes · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
This DTC is output when the VSC system detects a malfunction in the ABS.| DTC Code |
DTC Detection Condition |
Trouble Area |
| 43 |
A malfunction in the anti-lock brake system. |
Anti-lock brake system |
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. CHECK ANTI-LOCK BRAKE SYSTEM |
Clear the DTCs (Click here).
Turn the ignition switch to ON.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC not output (ABS DTC)
A
DTC output (ABS DTC)
B
|
|
||||
| A | |
| 2. RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of approximately 40 km/h (25 mph) or more for 60 seconds or more.
Check if the same DTC is output (Click here).
Result Result
Proceed to
DTC is not output
A
DTC is output
B
|
|
||||
| A | ||
| ||
